Silicone Rubber Electrical Tapes

All tapes meet 14 CFR 25.853(a) at amendment 25-116; Appendix F, Part I(a)(1)(i) (60 Second Vertical Flammability Test).

Flame Resistant Silicone Rubber Self-fusing Electrical Tape with UL V-0 Compound

-65°F to +400°F / -51°C to +204°C Continuous Exposure: Higher Intermittent

The FlameShield™ FR Flame Resistant silicone tapes are manufactured with a UL V-0 recognised silicone formulation. These tapes are black in color.

Standard tapes (normally stocked):

Available as a rectangular tape in 1.00" width; Thickness 0.010", 0.020", 0.030" and 0.040" thick.

Special order tapes (MOV and/or MOQ may be in effect):

Available as a rectangula taper in additional widths of 0.50, 0.75, 1.25, 1.50" and also in triangular profile.

These tapes meet the MIL and A-A commercial specifications and are used for a variety of critical electrical wiring and cable splicing and protection applications.

Especially suited for aviation and marine environments, and outdoor weathering environments.

The tape has no adhesive, but sticks to itself (self-fuses or self amalgamating) when stretched and wrapped onto itself. The tapes starts curing within minutes, and after several hours cannot be unwound or removed without using a sharp knife or blade. This tape makes a waterproof, weatherproof and air tight protection.

FR Flame Resistant UL V-0 Silicone Rubber Electrical Insulation Tape

The triangular tape has a guideline stripe in the center which aids in achieving a 50% spiral wrap. Triangular levelwrap tapes provide a smooth surface on spiral wrapping, preventing the tape wrap area from snagging when pulling a wire or cable through a bundle or over objects or openings. Triangular tape is sometimes referred to as centerline tape due to the guideline in the middle of the tape.

FlameShieldä tapes meeting provide superior electrical insulation with a minimum of 300 volts per mil (.001") of tape thickness at 365°F / 180°C. A 20mil tape therefore provides 6000 volts per wrap of insulation value.

This tape is also used to wrap hydraulic connections and to make vibration resistant bumpers and spacers for wiring, cable, hose, pipes and lines. This tape is used to wrap and hold insulation in place on hot air ducts. Makes an in-situ bushing for protecting wiring at the backshell clamp.

Class I Type I and Type II tapes