Main Form Products > Tapes > Tapes: Silicone - Aviation / Military
Simrit® Freudenberg NOK ARMET® GUIDELINE® Equivalent Type I & Type II Self Fusing Electrical Insulating Silicone Rubber Tape
500°F / 260°C Continuous Exposure: Higher Intermittent
Simrit® Freudenberg NOK ARMET® GUIDELINE® equivalent silicone rubber self-fusing compression tapes meet many MIL and other commercial specifications and are used for a variety of critical electrical wiring and cable splicing and protection jobs. Especially suited for aviation and marine environments, as well as outdoor weathering environments.
The tape has no adhesive, but sticks to itself (self-fuses or self amalgamating) when stretched and wrapped onto itself. The tapes starts curing within minutes, and after several hours cannot be unwound or removed without using a sharp knife or blade. This tape makes a waterproof, weatherproof and air tight protection.
These tapes may be either red or black.
Available unsupported (no fiberglass substrate) or supported (with fiberglass substrate); the substrate limits the stretch of the tape to a maximum of 15% elongation. Unsupported tape has elongation of 300 to 500% minimum (thinner tape is 500%, thicker tape is 300%)
This tape is also used to wrap hydraulic connections and to make vibration resistant bumpers and spacers for wiring, cable, hose, pipes and lines. This tape is used to wrap and hold insulation in place on hot air ducts. Makes an in-situ bushing for protecting wiring at the backshell clamp.
SIMRIT® is a registered trademark of Freudenberg NOK.
How our eCommerce Shopping Cart Works - Orders paid by credit card, wire transfer, check, bank draft or PO number
To buy this product now on-line, use the shopping cart product selector below.
Any Problems?... Call 610-906-3549 for immediate help - Then press 1 for the Order Desk or 2 for Technical Support.